For a lot of property owners, repairing drywall can be stressful. Sure, you don’t really need to fix the damage by yourself, however, you still have to be concerned about it happening again. Here are the major causes why drywall usually gets damaged.
Damages on drywall are problematic and usually one of the issues that are too complicated to deal with. Moreover, most homeowners are new to these issues so they are not prepared for this. Once you can observe buckling, cracks, or holes in your walls, you have to certainly contact an expert drywall contractor Sacramento to have them checked and fix it right away if necessary. But, we have to know the major factors that may cause your drywall to be damaged. Read on this article to know more about them so that you’ll know what to look out for in the future.
Holes
Any sort of holes in walls can be identified as a structural concern. Holes can take place due to a lot of factors like doors that blowing doors open without a stopper before it hits the wall or when furniture bumped hard against the wall. If you can notice holes in your drywall, get it fixed and patched ASAP.
Termite damage
This is one of the biggest concerns for a lot of property owners. When you can see termite damage, contact an exterminator as soon as possible. You can easily determine if your drywall has termite damage when you can see pinholes, and hear a hollow noise while striking the wall. Moreover, wood damage and damaged paint are some of the signs.
Cracking
If your drywall is installed badly, then cracks are more likely to happen and it can usually be seen in ceilings. By the time you can notice some cracks, you really have to call a drywall pro to come and assess the damage and fix it right away.
Poor fastening
Most of the time, drywalls are installed and connected using joint fastening tape. Eventually, this thick tape can become loose as a result of moisture or age and begin to wrap the drywall that it holds together. If this is the case, it can be very visible and obvious in your walls. Sometimes, it gets apparent that drywall was installed poorly when you can observe popping nails through the wall. When this occurs, it means that drywall nails aren’t actually set in the stud. But make sure to refrain from hammering the popping nail in place. It would be best to just take it out and look for the stud first before you fasten it into place.
Plumbing leaks
Water damage is among the top causes of broken drywall. When you have older plumbing that’s been poorly set up, you can potentially run into a few big problems over time. Among such problems include water damaged drywall. When you can see some bulging on your drywall, then check it as soon as you can and fix the damaged waterline that might’ve been covered there. Then, you can patch or replace the drywall.
Recent Comments